How to connect a hard disk
You will need
- Phillips screwdriver for computers
Take a hard drive and read the information on the sticker. There must be indicated the location of jumpers (special jumpers) for a clear definition of the disk in the system. Set the jumpers on the back of the hard drive to Master if the drive is bootable or the only one in the system. Set the jumpers to the Slave position if the disk is additional to the existing one.
Disconnect the power supplied to the computer motherboard by turning the toggle switch on the back of the system unit to the off position. Unplug the power cord from the outlet.
Remove both walls of the system unit, after unscrewing the screws on the back wall of the system unit case or squeezing the latches. Choose a location for the hard drive.
Insert the hard drive into the hard drive compartment. Secure it on both sides with screws, aligning the holes in the hard disk with the holes in the system block.
If the jumpers are set to Master, then the connector of the loop that is farthest from the mother card should be inserted into the hard disk.
How to make a web
How to return the property
Congratulations on Apple Spas 2018 - beautiful and funny in pictures and postcards, verses and prose, short SMS
How to find out the number of SNILS online
Weather in Anapa on May 2018 - forecast of the Hydrometeorological Center on air and water temperature at the beginning and end of the month
When to sow cucumbers in 2018 according to the lunar calendar
How your child’s precious work can be turned into real jewelery. For centuries
Why perfectionism is bad